DIY Brooder Ring
Parts:
1
6’ x 1’ sheet of Hardboard
2 1½ ” x 1” x 1’
lengths of wood (1 pre-drilled and countersunk)
6 20mm panel pins
2 1½ ” posidrive screws
Method:
1. Drill and
countersink 2 holes in one of the pieces of wood.
2. Nail each piece of wood through the hardboard at each end on opposite sides
3.
Bend the hardboard around in a circle until the ends overlap. (Smooth
inside)
4. Then insert screws into
pre-drilled holes in the one piece of wood.
5. Screw through two thicknesses of
hardboard into the other piece of wood (from the inside).
5.
Suspend Broody Lamp over the ring
at a suitable height.
NB: If chicks
huddle in the middle (too
